Saturday, September 3, 2011
Honda shadow 750 Aero Saddlebag Installation Manual
TURN SIGNAL MOVEMENT 1. Refer to figure 2. Remove the seat. Security: DISCONNECT the BATTERY BEFORE ALL WIRING CHANGES 2. Disconnect the cables turn signals to and taillights below the seat. 3. remove the three bolts on each side, which ensures the fender to support striving for. 4. Lower fender onto tired and remote. 5 turn signals . remove from fender strut. Observe and marks "left" and "right" for reinstallation. 6. Cut each turn signal wire 03? from connector end and splice 24? of electrical wire. Turn signal brackets must be oriented forward (ears in brackets to the front). 7 license plate . Remove light mounting bolts. Remove the pressure adjustment. The route turn signal cables through tom grommet hole references inserted in Figure 2, routing wire past the taillight and through the existing gap in the fender, with the help of the wire beat on the right side taillight bolt. Safe wire to taillight wire with the delivered tie wraps. 8. install the turn signal square between plate and plate bracket using 1/4-20 x 1 1/4 5? Hex Cap screw, 1/4 5? flat washer 1/4 5? x 1? fender washer and 1/4.35-20 locknut. 9 turn signals . Mount the bracket. Secure stalk to the bracket using 6 x 25 mm Hex Cap screw with a 1/4 5? flat washer.
Download Complete the Honda shadow 750 Aero Saddlebag Installation Manual.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.