Saturday, September 3, 2011
Ducati ST2 electronic Cruise Control Installation Manual
INSTALLATION of the CONTROL DEVICE THE CRUISE • remove cap screws from the clutch master cylinder mounting clamp on the handlebar (LHS); • Remove the clamp bracket from fork and use a file grinder or sandpaper on a flat surface, remove material, equivalent to about ½ switch mounting bracket thickness from bottom face of the clamp. • Insert two cap screws to clamp and the switch bracket with hardware on the bottom screw; • Unscrew the cap screws in the master cylinder by using a 5 mm hex key and position the master cylinder to ensure that the switch left parentheses doesn't interfere with other parts. Tighten the bottom Cap screw, then at the top one; • Run switch wire down the fork with line clutch hydraulic, then backwards until it rests in the LHS windscreen mount in front. The connector should be connected later. Cable tie wire to bar clutch in several places by means of small cable ties. INSTALL the COMPUTER: • position your computer as shown in the photo with the connecting Plug is pointing forward; • Thread the tie cable via the tab «top» on your computer and bind your computer tight to the top frame rail as shown in the photo; • Thread a cable tie through the lower tab on your computer, keeping it around lower frame rail and pull it tight.
Download Complete electronic Cruise Control Ducati ST2 Installation Manual.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.