Thursday, September 8, 2011
Suzuki C50/VL800 behind lowering Kit Installation Manual
Rear lowering Kit Installation: 1. determine how much you would like to reduce your motorcycle. Refer to reference the chart at the bottom of this page to determine the correct installation location holes to drop you want to achieve. 2. Ensure a motorcycle bike lift and lift the rear wheel motorcycle, so is unweighted. 3. Loosen and remove the two self-locking nuts, and flat washers from connecting arm bolts from the left side of the vehicle. 4. slide the connecting arm bolts from the right side of the motorcycle (it is necessary to push bushing back to the left side to allow the bolt head to drop below budget. Reinstall of the same manor) and replace equipment linking arms with your new LA Choppers lowering kit. End with single hole goes to the rear of the vehicle and attaches to the frame. The year with two holes faces towards the front of the motorcycle. Use the holes that lower behind your selected amount. Reinstall the bolts, washers and nuts. Torque the two connecting lines arm nuts to 35 foot pounds (48 Nm). Remove the motorcycle from the lift.
Download
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.