Saturday, September 3, 2011
1998-2001 Ducati 996 Power Commander III Installation Manual
1) Lift the rear section. 2) removing the left hand side wind screen. 3) Find the plug, residing in between two throttle bodies. This plug has a round silver preserve ring at the end of it. 4) Screw this connector by turning it counterclockwise. 5) Note: you can route cables from PCIII from the tail to this area before connecting it. This will make for a cleaner installation. Insert the female plug wiringfrom PCIII in. 6) Plug male connector from PCIII in the female connector on a left parenthesis. 7) Route cables along the frame to the rear of the bike. Make sure the wires are routed so that they do not get caught. 8) Attach the Earth wire from PCIII to front, left hand, the mounting point of the ECU. 9) Attach PCIII at the top of the ECU using the supplied Velcro fastening. 10) reinstall the left hand side wind screen.
Download Complete the 1998-2001 Power Commander Ducati 996 III Installation Manual.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.