Saturday, September 3, 2011
Aprilia RS125/RS250/RSV Mille/shiver/Dorsoduro/Thunder/Falco pipes Kit Installation Manual
Signal wire 1. Clips about 5 cm (2.35) away from the sensor connector. Catch the end of the wire that goes to the sensor and deprive from approximately 1 cm (0.4 5?) insulation. Splice White SH wire to this point, and isolate the delivered or electrical tapeshrink tubes. 2. Similarly, splice Green SH wire to the other wire signal cablelate. 3. Splice black SH wire rope speed Sensorto Earth, or any other ground wire. 4. Splice red SH cord to the Power wire speed Sensor, or any other fused power lead. 5. Make sure that all connections and insulations are good. 6. connect the 4-pole wires connection to box SH 7. Check if SH is installed and working properly: – have ignition. – Press and hold the SEL depressed while you turn the ignition. [t] (test) is now provided. Release the button. Speedo should specify a number other than zero. -Rotate the rear wheel. [t] should be blinking as the wheel turns. – Press SEL to exit from the test mode. Speedometer should work the same way as with no SH installed. 8. Find a place in your bike for box SH concerning the following: – to be able to change the settings for easy, place the device where it is quickly available. – Often wet areas should be avoided. -Do not place the device very close to warm places like the engine or exhaust pipe. – Holding of at least 2 cm (sat) distance to other electronics, such as the racing ECU, or a Power Commander. In most cases, in-seat space the best placement for the box. Ensure the device with the supplied Velcro strip.
Download Complete the Aprilia RS125/RS250/RSV Mille/shiver/Dorsoduro/Tuono/Falco pipes Kit Installation Manual.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.