Saturday, September 10, 2011
Installation guide system subwoofer BMW E39
D110.For the BMW E39 5 series M5 ' 97-' 03 – standard audio cable
We are going to proceed as follows:
-Accommodation factory amplifier
-Mounting on new amplifier
-Power connections for the new amplifier
-Audio inputs for the new amplifier
-Join a new amplifier new subwoofer enclosure
-Installation of the new enclosure subwoofer
Tuning/testing new amplifierAccess to the factory amplifier:
Simply Fold down the Bay to the driver's side of the trunk, and you'll see plant amplifier.
That's where we'll be doing our audio input connections:
Installation of your new amplifier
You want to start with the first solution to exactly where you want to connect your new amplifier. From there, you decide on appropriate ways to launch your wires.
Amplifier is an ideal place for a subwoofer in our system is located directly in front of the factory where the amplifier, CD-changer located above. Most vehicles do not have a CD changer, and if you do, then it's time for iPod integration system!
We secure a new amplifier for plant amplifier, a strip of Velcro. Of course, there are several other ways to do it, but we want to be as Minimally as possible. As most of our connection wires are in the same field, installation is a breeze!
Power connector to your new amplifier: * before making any connections, we recommend that you disconnect the negative battery terminal battery life. This would eliminate any chance of electrical damage to the vehicle.
You want to deprive back approximately ½ "insulation from the end of the power wires, ground wire and a remote-control rotate wire for solid compounds in new amplifier. Screw terminals on new amp should make a strong link with copper wiring and insulation of wires.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.