Online repair manual

BMW K1200S, K1200R K1200GT led flashing stop lamp Kit

CAN bus owners to install fuse block with the ignition switch moved to simplify installation and maintenance of all electrical accessories. Hyper-Lites and other accessories may be installed in fuse block without interference from the can bus system.Flasher unit is installed on a Flash continuously while the brakes are used. To convert the 5 seconds, then Flash solid while the brakes are applied, reduce the cycle of green wire on the flasher. Use electrical tape to protect and secure the Green wire to the other wire.
1. If using numbered bracket install now (instructions on the bracket of the package).
2. remove the rear seat. An empty storage compartment. Remove the two Torx head # 25 screws (see Figure 0) who keep taillight lens. Deleting assemblies bulb braking and svisaûsem gently, wires. (Figure 1)
3. connect the LED modules (net area with alcohol) that indicators pointed straight back. Click on the spot about 5 seconds. Tape can be used only once! If you are a fool, new tape is required.
4. Locate the Brown wire bike from terrestrial Terminal stop signal, use one of the sets of expert TAP connectors to tap into the wires. The band Hyper-Lite black wire ? in. .. . Insert stripped black wire into the free end of expert-TAP and tighten the TAP expert instructions.
5. Select a spot on the transaction side taillight Assembly mount flasher module. With pure alcohol. After alcohol dried delete blue, spanning from the Ribbon and click flasher on the surface of the mounting at 5 seconds.
6. find motorcycle grey wire from both light Sockets. Install the Hyper-Lite Kit red wire on a motorcycle, grey wire by using one of the sets of expert TAP connectors ...
7. If you have a power switch with fuse plugs relay route installed Hyper-Lite gray wire to fuses circuit fuse block (relays activated).
8. If you do not have a Fuse block is installed, find the loopback connector devices under the seat. Hyper-Lite route grey wire from module flasher green with a white stripe wire, attached to the chain alarm (see Figure 2). Diagram of the signal has five wires. White with stripe Brown wire, white with a black stripe red wire, spoke wire, Brown and green with a white stripe wire. Pull wire loom from the wire. Click on the green with a white stripe wire with an expert TAP provides.
9. the route of the blue and brown wires from flasher for LED modules. Finish blue and Brown wire to remove any excess wire. Strip each wire, 1/2. Twist expert connect using 3 blue wires together (see Expert-twist instruction). To connect 3 brown wires together use expert-twist.
10. replace the taillight Assembly. Try not to pinch the wire replacement taillight Assembly. Check out all the lights! When you install a set of flashing brake only, Hyper-Lite modules will blink when applying the brakes.

Source

Posted by manuels at 6:04 PM

Labels: bmw