Saturday, September 3, 2011
2008-2009 Honda CBR1000RR Dual canister Drop-on Installation Manual
1. Assure and exhaust components is fully COOLED. 2. ASSURE MOTORCYCLE is STABLE on STANDS or a REAR CENTER POSITION or SERVICE TABLE. 3. remove the PLASTIC COVER OVER 3 PLASTIC BUTTONS HOLDING the EXHAUST SERVO. (THIS IS LOCATED DIRECTLY INSIDE THE RIGHT REAR PASSENGER PEG BRACKET). 4. DISCONNECT the CABLE END FROM SERVO WHEEL and REMOVE the ENTIRE CABLE FROM RESTRAINT clip. THE ENTIRE CABLE WILL NOW REMOVE WITH THE REST OF THE EXHAUST GASES. 5. replace the PLASTIC COVER FOR SERVO and REINSTALL the BUTTONS 3 PLASTIC. STOCK MUFFLER 6. remove the mounting BOLT. 7. remove the STOCK EXHAUST CLAMP. (IT IS NOT UNCOMMON FOR CLAMP BOLT TO BREAK DURING REMOVAL.) 8. REMOVE the ENTIRE STOCK EXHAUST ASSEMBLY. BE CAREFUL NOT TO SCRATCH THE SWING ARM DURING REMOVAL. 9. remove the GASKET STOCK EXHAUST GAS FROM the HEADER PIPE IF IT DID NOT ORIGINATE with STOCK EXHAUST SYSTEM. THIS GASKET WILL NOT BE USED. 10. PREASSEMBLE HYPERFLO EXHAUST GASES before INSTALLATION. HYPERFLO RECOMMENDS YOU DO THIS PART ON THE CARPET OR A CLEAN PADDED AREA. YOU CAN ALSO USE PLASTIC BUBBLE PACKAGING AS PAD TO PROTECT SMOKE GRENADES DURING PREASSEMBLY.
Download Complete 2008-2009 Honda CBR1000RR Dual canister Drop-on Installation Manual.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.