Saturday, September 3, 2011
Aprilia RST1000 Futura HID Installation Manual
1. place your bike in centre stand. 2. Disassemble the hyphen, starting with the two top føreshus support located on the right and left side of the screen the wind. 3. Next remove two (right and left) dash side panels. It is not necessary to remove seat transition from the left panel. Just hang it over the side of the bike until you are ready to reinstall it. 4. When the side panels are off instrument cluster can be removed by taking out two top mounted socket cap screws (technical name of allen head bolts). When the screws are out carefully tilting instrument panel down to gain access to the two major electrical connector in the back. The release is on tabs clutch side of plugs. Push these in and plugs will draw right out of the back of the instrument cluster. 5. with the instrument cluster in addition you have access to the shelf areas to the right and left of the front are performing. Either side would keep a low beam ballast. Select a page and clean the area pay tribute. Use some sticky Velcro hook and loop to attach the ballast to the shelf. 6. Locate the power plug that goes into the ballast. This plug will have one blue and one black thread. Cut this thread to be 16 inches in length from Jack. Inspect from the marketing of ballast and see if you maybe shorter.
Download Complete The Aprilia RST1000 Futura HID Installation Manual.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.