Saturday, September 3, 2011
2006-2009 Kawasaki Ninja 650R electronic Jet Kit Installation Manual
Electronic Jet Kit Installation: 1. before you install TFI you must first disconnect the negative lead from the battery. 2. location of TFI Determinea specified volume of a unit. Suggested locations areas follows: Under the seat, behinda side door or tail section. 3. TFIcomeswitha wiring harness with injector connectors that corresponds to the factory injector connector. 4. Locate the factory fuel fuel injectors (see owners manual If you are not sure) *. *: Some models are equipped with two sets of fuel injectors (primary and secondary) unit is designed to interface with the primary fuel injectors. 5. Disconnect the factory injector connections from fuel fuel injectors and replace with TFI injector connections from TFI unit, basic unhook factory injector connector and set of matching connector (female) TFI to Injector and then ends the factory injector connector for TFI connector that simulates the injector (male).
Download Complete 2006-2009 Kawasaki Ninja 650R electronic Jet Kit Installation Manual.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.