Saturday, September 3, 2011
2004-2005 Ducati ST4s ABS pipes Kit Installation Manual
Signal wire 1. Clips about 5 cm (2.35) away from the sensor connector. Catch the end of the wire that goes to the sensor and deprive from approximately 1 cm (0.4 5?) insulation. Splice White SH wire to this point, and isolate the delivered or electrical tapeshrink tubes. 2. Similarly, splice Green SH wire to the other wire end of the signal cable. 3. Splice black SH wire rope speed Sensorto Earth, or any other ground wire. 4. Splice red SH cord to the Power speed Sensor, wire or any other fused power lead. 5. Make sure that all connections and insulations are good. 6. connect the 4-pole wires connection to box SH 7. Check if SH is installed and working properly: – have ignition. – Press and hold the SEL depressed while you turn the ignition. [t] (test) is now provided. Release the button. Speedo should specify a number other than zero. -Rotate the rear wheel. [t] should be blinking as the wheel turns. – Press SEL to exit from the test mode. Speedometer should work the same way as with no SH installed.
Download Complete 2004-2005 Ducati ST4s ABS pipes Kit Installation Manual.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.