Tuesday, January 31, 2012
Manual Mitsubishi Eclipse/Eclipse Spyder 3G
Inspection service points to BLOWN FUSE a remove fuse and measure the resistance between the side load fuse and the Earth. Set the switches all circuits that are connected to the fuse for continuity. If the resistance is almost 0 ? at present, there are short somewhere between the switches and load. If the resistance is not 0 ?, no short now, but perhaps a transient short caused a fuse to blow.The main reasons for shorting are as follows.
• Use clamped vehicle body
• Damage to the outer casing of the harness due to wear or heat
• Water, get into the socket or circuit
• Human error (incorrect short circuit etc.)
IDENTIFICATION NUMBER OF THE LOCATION OF VEHICLES
Vehicle identification number (VIN) located on plate attached to the top left of the toolbar.
PLATE OF THE VEHICLE IDENTIFICATION CODE CHART
All vehicle identification numbers contain 17 digits. Number of the vehicle is code that tells the country brand, vehicle type, etc.
PLATE OF THE VEHICLE IDENTIFICATION CODE
Vehicle code plate riveted on cowl top information bezel in the engine compartment. The plate shows the code model, the model of the engine, transmission model and body color code.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.