Online repair manual

1993 Mitsubishi Diamante transfer remove guide

1) Delete battery and the battery tray. The Diamante, 3000GT stealth and remove the secret (s). Model turbo intercooled. drain and remove On all models, remove the air cleaner and the case. Improve and maintain the vehicle. Remove the wheel. Disconnect the control cables to the transaxle automatic gearbox. Drainage transaxle automatic gearbox fluid.
2) 1.8 l disable Mirage born. On all models, disconnect the neutral security switch, the oil cooler hoses electrical connectors and transaxle automatic gearbox. Disconnect the throttle control cable and a speedometer (if available). Remove the starter.
3) models are equipped with electronically controlled suspension, remove the air compressor and brackets. Disconnect the front height sensor rod on the forearm.4) on all models, remove the Upper transaxle automatic gearbox engine bolts. Remove the engine undercover (if available). Remove the shafts of the actuator shaft. See FWD axis SHAFTS article in drive axles. Some less control arms from struts to access axis shafts (if necessary).
5) remove the front exhaust pipe (if necessary). The Eclipse AWD, 3000GT stealth and remove the right of members and gusset. AWD models of individual passing Assembly from transaxle automatic gearbox. Hyphen Assembly drive shaft and remove the transmission Assembly.
6) on all models, remove the cover transfer inspection (dust). Place the index mark on the torque converter and plate drive for assembly references. Remove the bolts and torque converter drive plate. Slide converter torque from the engine transaxle automatic gearbox.
7) on all models 4-cylinder engine support. All models support with Jack transaxle automatic gearbox. Remove the screws fastening transaxle automatic gearbox, mounting brackets and remaining screws engine transaxle automatic gearbox. The slide Assembly to the right and reduce transaxle automatic gearbox for deletion.
Make sure that the torque converter connected to a transaxle automatic gearbox before installation. Always install new snap rings on the inner constant connection speed.
Installation
1) for the installation, the removal procedure in reverse. Tighten the bolts to engine transaxle automatic gearbox and torque converter drive plate bolts specification. Torque specifications refer to the table at the end of this article.
2) make sure that the markup on the torque converter drive plate and transfer Assembly drive shaft alignment. Tighten the mounting bolts with the weight of the engine and transaxle automatic gearbox on mounts. Replenish liquid transaxle automatic gearbox to the specified level. Configure all of the cables and control cables. See the automatic gearbox, maintenance of the article.

here download

Posted by manuels at 7:56 PM

Labels: mitsubishi