Tuesday, January 31, 2012
Chrysler 318, 340 Manual guide
Kit installation
• Detach the battery to prevent accidental engagement starter.
• Refrigerant leakage from the system
• If your air conditioner intact and requested it to be evacuated. Best of all this is done by a professional garage with proper recycling equipment
Photo 1: make sure that the surface-mounted water pump are clean and free of the old material gaskets. Using silicon sealer and new gasket water pump installation (P171), using (2) 3/8 x 21/4 ? OTS (S260) in two lower holes pump water and one 8 x 11 3 / / 2 ? UTS (the S250) in the top center hole
• Removal of existing generator, air conditioning compressor and related mounts.
• Remove all pulleys and a water pump.
• Remove all traces of the old seal and sealer with a gasket scraper and steel wool pad.
• Net flows in the block, chasing the flow of fighters.
40440 kits remote power steering
Power steering bracket (13134-A), (3) M8 × 1.25 Photo 3 mount remote pump (P315) x 25 mm SHC (S551). Mount Bracket/RMG pump Assembly rear front bracket Chief, using (2) 3/8 x 1 SHC (S248) through the main bracket, bracket, power steering and 2 stainless steel spacer (S771).
Photo 3A sets without the helm or set # 40445 pump Saginaw mount (S771) in the main bracket below the drivers side of the center hole with x 1 (1) 3/8 TSS (S248) as shown. (1) 3/8 x 1 SHC (S248) and secured with nuts (S620) 3/8 "x 16 to fill the bottom openings
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.