Tuesday, January 31, 2012
Installation of Mount Bracketron phone Mitsubishi Montero 01-06
Installation instructions for Eclipse, Stratus Coupe and Sebring coupes. (See reverse side for the Mitsubishi Outlander, the Lancer/Sportback and Mitsubishi Montero instructions)Locate and delete the two (2) screws from the bottom of the trim bezel. With your hands or crop tool Dash (# SIT-104), release the bezel from all clips. There are two (2) clips at the bottom and two (2) at the top of the frame. Remove the bezel and carefully set aside.Locate and remove the two screws that secure the right side of climate control. Select the screws in a safe place. Put less of A hole, as shown in Figure average. Mill screws and tighten.
Reinstall the dash bezel, until all the clips are safe. Replace the two screws at the bottom of the frame. Once the bezel bimetallic, connect most of the "B" to a smaller part of the "A". To declare a Chrysler Sebring Dodge Stratus use holes (1). For Mitsubishi Eclipse use holes (2). The use of two (2) cap nuts and tighten part "b" part of "A" with a wrench open end 5/16 ".
Select any phone holder Bracketron or compatible device Amplifiers for your custom mount bezel. Your installation is complete.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.