Monday, November 21, 2011
2002 Chevy K 2500 Transmission Replacement Removal Procedure
Transmission Replacement Tools Required J 42371 Hydraulic Clutch Line Separator Removal Procedure 1. 2. 3. 4. 5. 6. Shift the transmission into 3rd or 4th gear. Remove the shift lever assembly. Drain the transmission fluid. If vehicle is a 2 wheel drive (2WD), remove the propeller shaft. If vehicle is a 4 wheel drive (4WD), remove the transfer case. Using J 42371, push back on the white plastic sleeve on the quick connect in order to separates the hydraulic clutch line from the clutch actuator quick connect. 7. Disconnect the following engine wiring harness electrical connectors: Backup lamp switch (1) Vehicle speed sensor (VSS) (3) Oxygen sensor (4) 8. Remove the oxygen sensor (2) from the transmission bracket. 9. Remove the engine harness clips from the fuel feed/return line clip/bracket. Zoom Sized for Print 10. If equipped with 4WD, remove the vent hose clip from the bracket. 11. If equipped with 4WD, remove the vent hose clip (1) from the fuel feed/return hose bracket. Zoom Sized for Print 12. If equipped with 4WD, remove the fuel feed/return hose clip from the bracket. 13. Remove the starter. 14. Support the transmission using a suitable transmission jack. 15. Remove the transmission support. Zoom Sized for Print 16. Disconnect the vent hose from the transmission. 17. Remove the vent hose clip from the clutch housing. Zoom Sized for Print 18. Remove the transmission to clutch housing bolts. 19. Remove the transmission from the clutch housing.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.