Monday, November 21, 2011
1996 Volkswagen Golf ADJUSTMENTS AIR BAG SPIRAL SPRING REMOVAL & INSTALLATION
SYSTEM OPERATION CHECK An air bag light is located on left side of instrument cluster. Air bag light is used to indicate readiness of system. Light glows when ignition switch is on or engine is started. Light should stay on about 3 seconds while air bag control unit performs an electronic test of system. If air bag light does not glow when ignition is on or does not go out after 3 seconds, a fault probably exists in system. If a fault occurs while ignition is on, it is stored in fault memory. Warning light will then glow and air bag system will be switched off. If warning light glows or flickers while driving, air bag system should be tested. See DIAGNOSIS & TESTING in appropriate AIR BAG RESTRAINT SYSTEM article in ACCESSORIES/SAFETY EQUIPMENT section. * * ADJUSTMENTS AIR BAG SPIRAL SPRING To center spiral spring assembly, turn spring assembly 3 turns from stop in either direction. REMOVAL & INSTALLATION WARNING: Failure to follow air bag service precautions may result in air bag deployment and personal injury. See SERVICE PRECAUTIONS. After component replacement, perform a system operational check to ensure proper system operation. See SYSTEM OPERATION CHECK. AIR BAG MODULE Removal 1) Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS. Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM. 2) Air bag module is located in steering wheel. See Fig. 1. Remove air bag module Torx head screws from rear of steering wheel. Lift off air bag module from steering wheel, and tilt air bag module downward. Disconnect air bag module connector. AIR BAG RESTRAINT SYSTEM – 1995 AIR BAG RESTRAINT SYSTEM – 1996download
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.