Online repair manual

SpeedoHealer Installation : 1. remove the left foot peg by removing the two 14 mm bolts securing to the motorcycle frame. 2. Next remove 10 mm bolt Breaks the selector on the farm. (Note: you may wish to select levers position in relation to the gear shaft to aid in the correct location during reassembly). 3. remove the four 5 mm Allen bolts holding on the left side cover. 4. When the cover is

Electronic Jet Kit Installation: 1. before you install TFI you must first disconnect the negative lead from the battery. 2. location of TFI Determinea specified volume of a unit. Suggested locations areas follows: Under the seat, behinda side door or tail section. 3. TFIcomeswitha wiring harness with injector connectors that corresponds to the factory injector connector. 4. Locate the factory fuel fuel injectors (see owners

Installation instructions: make sure that the bike is completely cold before you start the installation. Make sure that the bike is sure hand position or ideal lift service. Remove right side lower wind screen to postpone the muffler Assembly. Remove the four fasteners on the right side cover. Loosen the muffler clamp attachment OEM muffler to head pipe. Remove two muffler mounting bolts and remove OEM muffler.

Adjustable foot control installation: 1) to continue to the right side of the vehicle. Remove the line stock brake from the brake master cylinder rear and rear brake caliper. 2) remove the clevis pin attached to the brake lever rear brake master cylinder. 3) remove the rear brake master cylinder and let hang free. 4) Disconnect the rear brakes light from wires and remove the right foot control Assembly. 5) Mount collection right foot control is supplied in the kit to the frame with the stock screws. 6) Mount rear brake master cylinder to the foot control using the stock fasteners to be removed.

Contents: General information, intermittently fuel system, maintenance, cooling system, engine TopEnd, clutch, the engine lubrication system, the engine removal/Installation in the crankshaft/transmission, wheels/tires, Final drives, brakes, Suspension, steering, frame, electrical System.
1. Crankcase emission control system, this system eliminates the release of crankcase vapors into the atmosphere. Instead be routed by the vapors through an oil separator to the inlet side of the engine. While the engine is operating, be signed by vapors in the combustion chamber, where they burned with the fuel and air is supplied by fuel injection system. 2. Exhaust emission control system, this system reduces the amount of pollutants released into the atmosphere of